10
OC1 Watch/Dive Computers are placed in a Deep Sleep mode prior to being
shipped from the factory. The intent is to extend storage life of the Battery for
up to 7 years, before the unit is initially placed in service.
In this mode, Date and Time are updated as they normally would be. However,
they are not displayed. Upon waking the OC1 up, the correct Date and USA
Pacific Time will be displayed and it will be ready to operate with full functions.
To wake the OC1 up from Deep Sleep mode, simultaneously depress the upper/
right (S) and lower/left (A) buttons for 3 seconds until the display comes full ON
displaying the Watch Main Time screen, then release them.
NOTE: Once the OC1 is brought out of the Deep Sleep mode,
it can only be placed back into it by the factory.
NOTICE
STORAGE and INITIAL ACTIVATION
To Next Page
Loading...
Need help?
General
