Oceanic OC1 - Set CDT

133
Set CDT, information includes (Fig. 128):
> Graphics SEt and CD TMR
> CDT (min:sec) with Minutes digits flashing
> Time (clock) icon
• A (hold) to scroll upward through Minute Set Points at a rate
of 8 per second from 0: to 59: in increments of 1: (min).
• A (< 2 sec) to step upward through Set Points one at a time.
• M (< 2 sec) to step back through Set Points one at a time.
• S (< 2 sec) to save the Minute Set Point and flash the
Seconds digits.
• A (hold) to scroll upward through Seconds Set Points at a
rate of 8 per second from :00 to :59 in increments of :01
(sec).
• A (< 2 sec) to step upward through Set Points one at a time
• M (< 2 sec) to step back through Set Points one at a time.
• S (< 2 sec) to save the CDT Set Point and revert to the CDT
Status screen with SET flashing (similar to Fig. 127B).
The CDT will run in the background, while on the surface and
during dives, until it counts down to 0:00, or it is turned OFF.
When a set Countdown Time reaches 0:00, the Audible Alarm
will sound during which time the graphic CDT will be displayed
with 0:00 flashing on the Surface or Dive Main (Fig. 129).
Fig.128-SETCDT
(min:sec)
Fig.129-SURFACEMAIN
(duringCDTalarm)