7 Set up and Connection
Instruction Manual Keratograph 5M (G/77000/XXXX/EN – Rev05) 23 / 106
7 Set up and Connection
Attention
Improper measurements/equipment damage due to improper set-up
Before first use, make sure the installation and connection of the
“Keratograph 5M” examination station are completed by our ser-
vice or by a professional authorized by OCULUS.
Let OCULUS or an authorized dealer train you in the operation of
the Keratograph 5M.
Note
Risk of damage to the devices if not handled properly
Do not expose the Keratograph 5M to any vibrations, shocks, con-
taminants, moisture, or high temperatures.
Handle the optical device with care.
The ambient conditions for operation are given in Chap. 26, page 92.
Set up the Keratograph 5M so that the power plug is easy to ac-
cess. That way, you can easily disconnect it from the power supply
for any repairs or maintenance work.
Place the device so that direct light cannot affect the measurement.
Make sure the examination is free from reflections. To achieve this,
darken the examination room.
7.1 Connect Foot Switch
If needed, you can connect a foot switch. With this, you can trigger the
image capture. For a video, you can start and stop the recording by
pressing this foot switch, Chap. 17.5, page 59.
Prerequisite: USB port
Plug the USB connector of the foot switch into a USB port at your
computer.
The foot switch is active.
7.2 Electrical connection
Caution
Impairment of electrical safety
Do not use the Keratograph 5M directly next to other devices and
do not stack it on top of other devices.
If you have to use the Keratograph 5M adjacent to or stacked with
other equipment, verify the correct operation of the
Keratograph 5M.
Only use the power adapter listed in the packing list, Chap. 27.1,
page 95.
Use only a mains cable that meets the requirements of
IEC 60227-1, Type H05V V-F, min. 0.75 mm² and of IEC 60320-1,
Type C7.
To Next Page
Loading...
