Oki B721

Oki Data CONFIDENTIAL
45487001TH Rev.1
6-7 /
6. Troubleshooting procedure
LCD Status Message
( represents a blank line.)
READY
indicator
ATTEN-
TION
indicator
Beep Details
Remedial
measure
Print Cartridge
Near Life
Varies On
(Blink)
(Off)
–
(On)
Print Cartridge amount is low.
Displayed in a combination of other
message in the first line.
Printing is continued until it is set to
Print Cartridge Empty.
Moreover, when set as Admin
Setup "Panel Setup"-"Near Life
LED"=Disable, Attention LED is
switched off.
–
Non OEM Toner
Detected
Varies On –
It shows the toner cartridge of
authorized 3rd party. (Tag Licensed to
3rd party)
Urge the
user to
use proper
toner
cartridge.
Non OEM Print
Cartridge Detected
Varies On –
It shows the Print Cartridge of
authorized 3rd party. (Tag Licensed to
3rd party)
Urge the
user to use
proper
Print
Cartridge
.
Incompatible Toner
Varies On – The Region ID of toner cartridge
is not proper to the distribution
channel.
Urge the
user to
use proper
toner
cartridge.
Incompatible Print
Cartridge
Varies On – The Region ID of Print Cartridge
is not proper to the distribution
channel.
Urge the
user to use
proper
Print
Cartridge
.
Non Genuine Toner
Varies On – The chip of Tag is not compatible. Urge the
user to
use proper
toner
cartridge.
Non Genuine Print
Cartridge
Varies On – The chip of Tag on Print Cartridge is
not compatible.
Urge the
user to use
proper
Print
Cartridge
.
Toner Sensor Error
Varies On – Something is wrong with the toner
sensor.
–
LCD Status Message
( represents a blank line.)
READY
indicator
ATTEN-
TION
indicator
Beep Details
Remedial
measure
Error Postscript
Blink Varies – Interpreter detects an error due
to the following reason. Receive
data after this is ignored until the
job completion. When the job
is completely received, this is
automatically cleared.
- The job has a grammatical error.
- The page is complicated, and VM
was used up.
–
Image Drum Near
Life
Varies On
(Off)
– The life of the drum (warning).
Displayed in a combination of other
message in the first line. The printer
stops at the point when it reaches
the drum life (Shifts to error, OFF-
LINE.)
Moreover, when set as Admin Setup
"Panel Setup"-"NearLifeLED" =
"Disable", Attention LED is switched
off.
–
Print Cartridge Near
Life
Varies On
(Off)
–
The life of the Print Cartridge (warning).
Displayed in a combination of other
message in the first line. The printer
stops at the point when it reaches the
drum life (Shifts to error, OFF-LINE.)
Moreover, when set as Admin Setup
"Panel Setup"-"NearLifeLED" =
"Disable", Attention LED is switched
off.
–
Fuser Unit Near
Life
Varies On
(Off)
–
Notifies the fuser unit is near its life.
Moreover, when set as Admin Setup
"Panel Setup"-"NearLifeLED" =
"Disable", Attention LED is switched
off.
–