Oki Data CONFIDENTIAL
42615101TH Rev.8 183 /
Table 7-1-2 Service Call Error (4/7)
Service call
142:Error
Service call
150:Error
~
153:Error
Service call
154:Error
Service call
155:Error
Service call
160:Error
~
163:Error
Service call
170:Error
171:Error
Service call
172:Error
173:Error
Service call
174:Error
Is ID unit set properly?
Does error reoccur?
Is ID unit setting proper?
Does error reoccur?
Is error recovered by replacing
PRT board?
Is belt unit setting proper?
Does error reoccur?
Is fuser unit set properly?
Does error reoccur?
Is toner cartridge setting?
Is toner lock lever setting?
Does error reoccur?
Does error reoccur?
Does error reoccur?
Does error reoccur?
Reset ID unit.
Turn power ON again.
Replace ID Up/Down
sensor.
Reset ID unit.
Turn power ON again.
After check connec-
tions of cable between
PRT board and PU
board, replace PRT
board.
Replace PU board
(PRN)
Reset belt unit.
Turn power ON again.
Check cable connec-
tions and, replace PU
board(PRN)
After cleaning for fuser
connector, reset.
Turn power ON again.
Check cable connec-
tions and replace PU
board (PRN)
Set toner cartridge.
Turn a lock lever of
toner to a fixed position.
Replace toner sensor
or assembly.
Turn power ON again.
Replace fuser unit.
Turn power ON again.
Replace fuser unit.
Turn power ON again.
Replace fuser unit.
Error detected at
ID position of Up/
Down
ID unit fuse
cannot be discon-
nected. (150 = Y,
151 = M, 152 = C,
153 = K)
Belt unit fuse
cannot be discon-
nected.
Fuser unit fuse
cannot be discon-
nected.
Error detected by
toner sensor. (160
= Y, 161 = M, 162
= C, 163 = K)
It does not occure
in factory default
setting.
Short circuit in
fuser thermistor
or open detected.
Abnormal tem-
perature detected
by fuser ther-
mistor (high-temp
or low temp.)
Short circuit in
back up roller
thermistor de-
tected (at high
temperature).
Ye s
No
Ye s
No
Ye s
Ye s
No
No
Ye s
Ye s
No
Ye s
Ye s
No
No
Ye s
Ye s
Ye s
Ye s
Error DescriptionMessage Cause Solution
To Next Page
Loading...
Need help?
General
