Oki C542dn Advanced Manual

- 126 -
5. Operating Management/ Specifications
• Drum Cleaning
•Hex Dump
Color Menu
System Configuration Menu
PCL Setup
Item Factory
default
setting
Description
Drum Cleaning OFF Sets whether to clean the drum before printing. The image
quality improvement may be expected.
Item Factory
default
setting
Description
Hex Dump OFF Prints out the data received from the host computer in hex. To
finish printing, turn off the machine.
Item Factory
default
setting
Description
Density Control Auto Select "Auto" or "Manual" for adjusting density.
Adjust Density - Adjusting density is performed right after this menu is selected.
Color Tuning / Print Pattern - A test page is printed for checking the adjusting value to be
entered for any other C/M/Y/K Tuning menus.
Cyan Tuning Cyan Highlight 0 Adjust the value for Highlight / Mid-tone / Dark of each color
within a range of -3 to +3.
+ : Adjusted to be darker.
- : Adjusted to be lighter.
Cyan Mid-Tone 0
Cyan Dark 0
Magenta Tuning Magenta
Highlight
0
Magenta Mid-
Tone
0
Magenta Dark 0
Yellow Tuning Yellow Highlight 0
Yellow Mid-Tone 0
Yellow Dark 0
Black Tuning Black Highlight 0
Black Mid-Tone 0
Black Dark 0
Color Density Cyan Density 0 Adjust the total density of each color within a range of -3 to +3.
+ : Adjusted to be darker.
- : Adjusted to be lighter.
Magenta
Density
0
Yellow Density 0
Black Density 0
Adjust Registration Color registration adjustment is performed.
Ink Simulation OFF Sets the ink simulation. This setting is enabled only for PS
language jobs.
UCR Low Adjusts the level of under color removal.
CMY100% Density Disable Selects whether to use halftone for C, M, Y 100% density.
CMYK Conversion ON Selects whether to use simple (quick) mode when performing
CMYK Conversion.
This menu setting is disabled if using the ink simulation function.
Item Factory
default
setting
Description
Personality Auto Selects the emulation mode. If auto is set, the correct emulation
is automatically selected every time a print job is received.
Alarm Release Manual If [Manual] is set, non-critical warnings, such as requests for a
different paper size, can be cleared by pressing [RESET]. If
[Auto] is set, the warnings are cleared when the print job
resumes.
Auto Continue OFF Sets whether the machine automatically recovers from a
memory overflow.
Error Report OFF Sets whether to print error details if PostScript, PCL6 or XPS
errors occur.
Item Factory
default
setting
Description
Font Source Resident Selects the location of the font to use.
Item Factory
default
setting
Description

Oki C542dn Specifications

General

Brand	Oki
Model	C542dn
Category	Printer
Language	English