45376001TH Rev.1
137 /
Oki Data CONFIDENTIAL
5. Maintenance Menu
5.4 Density control manual setting
When a printer is shipped from the factory, the automatic density correction mode has
been set in "Automatic". If a printer is used after the density correction mode is set to
"Manual", density may change during usage of a printer. Actions to be taken when
density is not normal.
Note! Perform the followings while a printer is in the still state. Do not perform the
followings during warm-up.
(1) Press the [2] or [8] key several times until the [Calibration] is displayed. Then,
press the [6] key.
(2) Press the [2] or [8] key to display [Adjust Density/Execute].
(3) Press the [6] key.
The automatic density correction starts.
To Next Page
Loading...
