5-2 Using Field Sensors
Field Sensor Logs
The camera records sensor and GPS data at regular intervals to create a log. Logs
can be viewed using the “OLYMPUS Image Track” (OI.Track) smartphone app. You
can see the route you traveled with your camera and the locations where pictures
were taken.
Use [Field Sensor Logger] in G Custom Menu Q to start logging sensor data.
Location data will be recorded if they can be acquired via GPS.
Logging Data (Field Sensor Logger)
When logging starts, the camera records the data internally. The data are saved to
a memory card when logging ends. Logging will continue even while the camera is
off. Logging is available only if the camera clock is set. g [X Settings] (P. 455)
• Logging ends if:
- The battery level falls below 15%
- The camera can no longer record the log data internally
The following options are available:
Start Log Start logging.
Stop Log
End logging. The data recorded internally will be transferred to a memory card.
If two cards are inserted, you will be prompted to choose the card used to store
the log.
Save Log
Copy the current log from internal memory to a memory card. If two cards are
inserted, you will be prompted to choose the card used to store the log. Saving
the log may take a few minutes.
• Logging cannot start or end while the camera is connected to a smartphone.
• A message will be displayed while the log is transferred to the memory card. Do not remove
the card while the message is displayed. Failure to observe this precaution could result in
the log being lost or in damage to the camera or card.
• Logs cannot be saved if the memory card is full or otherwise unusable. Delete unwanted
data or take such other steps as may be needed to save the log.
• Each memory card can store a maximum of 199 log fi les. A warning will be displayed as this
limit approaches (P. 637). Insert another memory card or delete log fi les after copying them
to a computer.
• Selecting [Full] for [Reset / Custom Modes] (P. 91) > [Reset] in W Shooting Menu 1 does
not affect the option selected for [Field Sensor Logger]. The log currently stored in the
camera’s memory is not deleted and logging continues without interruption.
• The current log may be deleted from the camera’s internal memory during fi rmware updates.
Be sure to save the log to a memory card before updating camera fi rmware.
• While the camera is off, the power needed to log data is drawn from whichever battery
currently has the greatest charge, regardless of the chosen battery order.
571
EN
5
To Next Page
Loading...
Need help?
General
Weight and Dimensions
