Omni 7000 Series Installation Guide

OMNI 4000/7000 Installation Guide – Rev H
4-59
Configuration
Process I/O Module Configuration
In these instructions, we configure a new A module. Configuration steps for other
types of modules are similar, but the specifics of setup will be different, depending
on the module.
To configure Process I/O points, follow these instructions:
1.
Click the Configure button in the Home
ribbon to open the Configure tree in the
left panel.
2.
a. Click the + to expand the OMNI I/O
section in the tree.
b. Select and expand Process I/O;
then expand the module (in this
example, A-1).
c. Select Process Inputs to display
the configuration settings on the
screens to the right.
3.
Along the top of the screen are tabs for
each process input that is available on the
module. Fill in the required information in
these screens.
4.
After you have finished making your
selections and entering parameters for this
input, click the Apply button to save the
configuration.
Press F1 to access
OMNICONNECT Help for
assistance.

Omni 7000 Series Specifications

General

Brand	Omni
Model	7000 Series
Category	Desktop
Language	English