CHAPTER 13
| 95
FM MENU DISPLAY SETTINGS
For example, you may wish to devote one preset to nothing but the Undo and Processing Meters to display these parameters
in greater detail. Or, you could devote an entire preset to the oscilloscope and monitor the program input, the output of Undo,
the MPX before the clipper, and the MPX output to see what the various stages within Omnia.9 are doing to the audio signal.
The combinations are endless and yours to customize to suit your particular needs and preferences. Here is just an example of
a “fully stuffed” NfRemote display of eight metering stages, expanded to fill the screen. This shows the flexibility of metering
options available on the Omnia.9. Have fun configuring yours!
Displays: This is where you start
Undo Meters Menu
The Undo Meters button allows you to display the activity of the entire Undo section. Which specific Undo meters are
displayed within this window is determined by settings in the Undo Metering portion of the main Undo menu, which is located
in Omnia.9’s Input section. A full explanation of the Undo meters is given in the section dedicated to using Undo. Here is an
example of a typical Undo meter indication:
You can see how to select that particular display, by selecting Display 1, Main Meters, and Undo Meters. Follow the next
section to observe how to select other meter options to observe what is “going on” inside the Omnia.9.
To Next Page
Loading...
Need help?
General
