OmniPod ENT450 - Lock or Unlock the PDM Buttons; Screen Time-Out; Backlight Time-Out

63
Adjusting Settings 77 Adjusting Settings
Check the alarms and vibration
To reassure yourself that your PDM and Pod's alarms and vibration functions are
working properly, you can test them as follows:
1. If you have an active Pod, you must suspend it rst: Home > Suspend
2. Go to: Home > Settings > System setup > Diagnostics > Check alarms
3. Press Select and then press OK to initiate the alarm check.
4. Listen and feel: e PDM beeps three times and vibrates three times. en, if
you are wearing a Pod, the Pod beeps several times and sounds the alarm tone
for several seconds.
Warning: If the PDM fails to beep, call Customer Care immediately. If an
activated Pod fails to beep, change the Pod immediately. Continuing to use the
Omnipod® System in these situations may put your health and safety at risk.
Lock or unlock the PDM buttons
You can lock the PDM to prevent accidentally changing Basal Programs or giving
boluses. When the PDM is locked, you can still use the built-in BG meter, check
your history records, and unlock the PDM.
1. Home > Settings > System setup > PDM options > PDM lock
2. Choose On to lock the PDM or O to unlock it. en press Select.
Screen time-out
To preserve battery power, the PDM screen turns o if you have not pressed a
button for the specied time interval. To change the amount of time before the
PDM's screen goes blank:
1. Home > Settings > System setup > PDM options > Screen time-out
2. Select a screen time-out interval, then press Select.
Tip: Set this time-out interval to the lowest setting to preserve battery life.
Backlight time-out
e PDM's screen can dim prior to going blank. To change the amount of time
before the PDM's screen dims:
1. Home > Settings > System setup > PDM options > Backlight time-out
2. Select a backlight time-out interval, then press Select.
Tip: Set this time-out interval to the lowest setting to preserve battery life.