2-5
2 Basic System Configuration and Devices
CJ2 CPU Unit Hardware User’s Manual
2-1 Basic System Configuration
2
2-1-2 CPU Rack
z End Cover
*1 One End Cover is provided with the CPU Unit and with an I/O Interface Unit.
Model Specifications
Current con-
sumption (A)
Weight
CJ1W-TER101 Must be connected to the right end of the CPU Rack. (A
fatal error will occur if the End Cover is not connected to
the right end of the Rack.)
*1
Included with
CPU Unit and I/O
Interface Unit.
---
Others
Name Model Specifications
DIN Track PFP-50N Track length: 50 cm, height: 7.3 mm
PFP-100N Track length: 1 m, height: 7.3 mm
PFP-100N2 Track length: 1 m, height: 16 mm
PFP-M Stopper to prevent Units from moving on the track.
Two each are provided with the CPU Unit and with
an I/O Interface Unit.
Programming Device Connecting
Cable for peripheral (USB) port
Commercially available
USB cable
USB 2.0 (or 1.1) cable (A connector - B connec-
tor), 5.0 m max.
Programming Device Connecting
Cables for serial port
XW2Z-200S-CV Connects to IBM PC/AT computer
D-Sub 9-pin connector (Cable length: 2.0 m).
Uses static-resistant connector.
XW2Z-500S-CV Connects to IBM PC/AT computer
D-Sub 9-pin connector (Cable length: 5.0 m).
Uses static-resistant connector.
XW2Z-200S-V Connects to IBM PC/AT computer
D-Sub 9-pin connector. (Cable length: 2.0 m)
*1
XW2Z-500S-V Connects to IBM PC/AT computer
D-Sub 9-pin connector. (Cable length: 5.0 m)
*1
Connecting Cable for EtherNet/IP
port
Commercially available
100Base-TX twisted-
pair cable
Recommended: Fujikura F-LINK-E 0.5 mm × 4P
Twisted-pair cable with RJ45 Modular Connectors
on both ends. Connect between EtherNet/IP Unit
or built-in EtherNet/IP port and switching hub.
Use STP (shielded twisted-pair) cable of category
5 or 5e.
To Next Page
Loading...
