8 - 15
8 Operation
OMNUC G5-series (Pulse-train Input Type) AC Servomotors and Servo Drives User’s Manual
8-4 Mode Setting
8
8-4-2 Monitor Mode
Do not set.
Do not set.
Display of the Number of I/O Signal Changes
Reserved
Reserved
Monitor for the Number of Encoder Communications Errors
... Input signal
... Output signal
Number of I/O signal changes
Pin No.
It is possible to change the pin number if the decimal
point is located on the right of the pin number.
It is possible to switch input and output, if the decimal
point is located between the pin number.
Press to move the flashing decimal point.
Press to switch input and output.
... Encoder ... Reserved
Number of communications error
Press to switch “Encoder” or “Reserved”.
To Next Page
Loading...
