Omron G5 Series - Page 487

A - 21
Appendices
OMNUC G5-series (Pulse-train Input Type) AC Servomotors and Servo Drives User’s Manual
A-2 Parameter List
A
406 Input Signal
Selection 7
Set the function and logic of input signal 7. 3,847 – 0 to
00FFFFFF
hex
Required
407 Input Signal
Selection 8
Set the function and logic of input signal 8. 263,172 – 0 to
00FFFFFF
hex
Required
408 Input Signal
Selection 9
Set the function and logic of input signal 9. 328,965 – 0 to
00FFFFFF
hex
Required
409 Input Signal
Selection 10
Set the function and logic of input signal 10. 3,720 – 0 to
00FFFFFF
hex
Required
410 Output Signal
Selection 1
Set the function assignment of output signal 1. 197,379 – 0 to
00FFFFFF
hex
Required
411 Output Signal
Selection 2
Set the function assignment of output signal 2. 131,586 – 0 to
00FFFFFF
hex
Required
412 Not used Do not change the set value. – – – –
413 Output Signal
Selection 4
Set the function assignment of output signal 4. 328,964 –
0 to
00FFFFFF
hex
Required
416 Analog Monitor
1 Selection
Select the type of analog monitor 1. 0 – 0 to 21 –
0 Motor speed
1 Position command speed
2 Internal position command speed
3 Speed control command
4 Torque command
5 Position command error
6 Encoder position error
7 Reserved (Do not set.)
8 Reserved (Do not set.)
9 P-N voltage
10 Regeneration load ratio
11 Overload load ratio
12 Forward direction torque limit
13 Reverse direction torque limit
14 Speed limit value
15 Inertia ratio
16 Reserved (Do not set.)
17 Reserved (Do not set.)
18 Reserved (Do not set.)
19 Encoder temperature
20 Drive temperature
21 Encoder 1-rotation data
417 Analog Monitor
1 Scale Setting
Set the output gain of the analog monitor 1. 0 –
0 to
214,748,364
–
Pn
No.
Name Setting Description
Default
setting
Unit
Setting
range
Cycle the
power
supply