2-4 HS-360X Handheld DPM Scanner User Manual
HS-360X Wireless Scanner Beeper and LED
Battery Indications
Low battery indication (on trigger
release)
Four short high beeps Red (stays on)
Battery LED status
99-51% Green
21-50% Amber
0-20% Red
Battery end of life
99-51% Green/red alternating
21-50% Amber/red alternating
0-20% Red blinking
Parameter Programming
Input error, incorrect barcode or
Cancel scanned, wrong entry,
incorrect barcode programming
sequence; remain in program
mode.
Long low/long high beeps Red
Keyboard parameter selected.
Enter value using barcode keypad.
High/low beeps Green
Successful program exit with
change in the parameter setting.
High/low/high/low beeps Green
Cancel rule entry. Rule entry mode
exited because of an error or the
user asked to exit rule entry.
Long low/long high/long low beeps
Green
(turns off blinking)
Host-Specific: USB-Only
Scanner has not completed
initialization. Wait several seconds
and scan again.
Four high beeps None
Host-Specific: RS-232-Only
RS-232 receive error. High/high/high/low beeps Red
A <BEL> character is received
when Beep on <BEL> is enabled
(Point-to-Point mode only).
High beep None
Event Beeper Sequence LED
To Next Page
Loading...
