Omron SYSDRIVE 3G3MV - Page 238

7-44
·The following memory allocations are made in the above example.
SYSMAC CS1-series or C200HX/HG/HE
Programmable Controllers
Communications
Board
3G3MV
C: Control data (see note)
Communica-
tions port
1: Port A
2: Port B
Sequence No.
000 to 999 (BCD)
Data
No. of data items send in accordance with PMCR
instruction (000A)
No. of Slaves (0003)
First Slave address (0001)
RUN command to Slave 1
Frequency reference to Slave 1
Second Slave address (0002)
RUN command to Slave 2
Frequency reference to Slave 2
Third Slave address (0003)
RUN command to Slave 3
Frequency reference to Slave 3
No. of data items received in accordance with
PMCR instruction (0003)
Slave 1 Inverter status
Slave 2 Inverter status
Slave 3 Inverter status
Note Control data on the SYSMAC
C200HX/HG/HE is indicated.
The SYSMAC CS1 Series uses
different control data.
Protocol macro function
H Creating a New Project and Protocol
1. SelectNew fromtheFile intheMenuBarorclickontheNewicon withtheleftbutton
of the mouse to create a new project.
2. If CX-Protocol is used, set the PC name, PC model, and network type according to
the actual conditions.
Note 1. The network type refers to the type of the network connected to the Support
Softwareanditdoesnotrefertothecommunicationsconfigurationbetweenthe
Programmable Controller and the 3G3MV Inverter.
Note 2. The above settings will not be displayed if the Protocol Support Tool is used.
3. Double-clickonNew Projectwiththeleftbuttonof themouseto displayList ofPro-
tocols.
4. Click on List of Protocols with the left button of the mouse and click on a blank
space with the right button of the mouse.
5. Select New Protocol.
Communications Chapter 7