Omron SYSDRIVE 3G3MV - Page 249

7-55
D Inverter Control Output (Register 002C Inverter Status)
Word Slave 1 function Word Slave 2 function Word Slave 3 function
01100 RUN 01200 RUN 01300 RUN
01101 Stop 01201 Stop 01301 Stop
01102 Frequency coincide 01202 Frequency coincide 01302 Frequency coincide
01103 Alarm (Nonfatal
error)
01203 Alarm (Nonfatal
error)
01303 Alarm (Nonfatal
error)
01104 Frequency detection
1
01204 Frequency detection
1
01304 Frequency detection
1
01105 Frequency detection
2
01205 Frequency detection
2
01305 Frequency detection
2
01106 Inverter ready 01206 Inverter ready 01306 Inverter ready
01107 UV 01207 UV 01307 UV
01108 Base block 01208 Base block 01308 Base block
01109 Frequency refer-
ence mode
01209 Frequency reference
mode
01309 Frequency refer-
ence mode
01110 RUN command
mode
01210 RUN command
mode
01310 RUN command
mode
01111 Overtorque detec-
tion
01211 Overtorque detec-
tion
01311 Overtorque detec-
tion
01112 0 (Not used) 01212 0 (Not used) 01312 0 (Not used)
01113 Fault retry 01213 Fault retry 01313 Fault retry
01114 Fault 01214 Fault 01314 Fault
01115 Communications
time-over
01215 Communications
time-over
01315 Communications
time-over
D Area Used by Operand of PMCR Instruction
·Control Data: C
Area
Communications
port A selected
Sequence 000 set
Note Control data on the SYSMAC
C200HX/HG/HE is indicated. The
SYSMAC CS1 Series usesdifferent
control data.
Communications Chapter 7