Omron SYSDRIVE 3G3MV - Page 250

7-56
·Send Data: S
DM Area
D1000 000A (No. of send data items: 10) (see note 1)
D1001 0003 (No. of Slaves)
D1002 0001 (Slave 1 address)
D1003 RUN command to Slave 1
D1004 Frequency reference to Slave 1
D1005 0002 (Slave 2 address)
D1006 RUN command to Slave 2
D1007 Frequency reference to Slave 2
D1008 0003 (Slave 3 address)
D1009 RUN command to Slave 3
D1010 Frequency reference to Slave 3
·Recv data: D
DM Area
D2000 0003 (No. of Recv data items: 3) (see note 2)
D2001 Slave 1 Inverter status
D2002 Slave 2 Inverter status
D2003 Slave 3 Inverter status
Note 1. Set the number of send data items in Hex to the number of words of D10001
through D1010 (10).
Note 2. The number of words ofD2001through D2003(3) is written inHex the number
of Recv data items.
Communications Chapter 7