Omron SYSDRIVE 3G3MV - Page 85

3-17
Key
sequence
ExplanationDisplay
example
Indicator
If there is a parameter set value that does not
coincide, the parameter number will flash.
Press the Enter Key so that the
corresponding set value in the Inverter will
flash.
Press the Enter Key again so that the
corresponding set value in the EEPROM of
the Digital Operator will flash.
Press the Increment Key so that verification
will resume.
Completes When the set values have been all checked,
“End” will be displayed.
or
Press the Mode or Enter Key. The parameter
number (n176) will be displayed again.
Note 1. The above operation is interrupted when the STOP/RESET Key is pressed
while the parameter number or parameter set value is flashing because the
parametersetvaluedoesnotcoincide.“End”willbe displayed.Bypressingthe
Mode or Enter Key, the parameter number (n176) is displayed again.
Note 2. Byattempting toverifytheparametersetvaluesin Invertersthataredifferentin
capacity,“vAE”flashesforacapacityerror.PresstheEnterKeytocontinuever-
ifying the parameter set values. To cancel the operation, press the STOP/RE-
SET Key.
Preparing for Operation and Monitoring Chapter 3