Omron SYSDRIVE 3G3MV - Page 84

3-16
If a set range error results, the corresponding parameter number will flash. In
the case of a verification error, “oPj” (j is a figure) will flash.
Note 2. The following parameter set values or output frequency on hold cannot be
copied.
n176: Parameter copy function selection n178: Error log
n177: Parameter read-prohibit selection n179: Software version
Note 3. The following parameter set valuescannot be copied if theInverters arediffer-
ent to each other in capacity.
n011 to n017: V/f setting n108: Motor leakage inductance
n036: Rated motor current n109: Torque compensation limit
n080: Carrier frequency n110: Motor no-load current
n105: Torque compensation core loss n140:Energy-savingcontrolcoefficientK2
n106: Rated motor slip n158: Motor code
n107: Motor wire-to-wire resistance
Note 4. Functions for 5.5/7.5kW Inverters cannot be copied to Inverters with different
capacities.
H Verifying the Parameter Set Values (vFy)
·In order to verify that the copied parameter set values in the Inverter coincide with
those in the EEPROM of the Digital Operator, set n176 for parameter copy function
selection to vFy.
Note The parameter set values can be verified provided that they are copied between
the Inverters that are the same in power supply specification and control mode
(i.e., V/f or vector control).
D Procedure to Verify the Parameter Set Values
Key
sequence
Indicator Display
example
Explanation
Power ON
Press the Mode Key repeatedly until the
PRGM indicator is lit.
Use the Increment or Decrement Key to
display “n176.”
Press the Enter Key. Then “rdy” will be
displayed.
Use the Increment Key to display “vFy.”
Press the Enter Key so that the parameter
set values are verified, during which the
display flashes.
Preparing for Operation and Monitoring Chapter 3