xiv
NSJ Series
Models Unit versions
NSJ@-TQ@@(B)-G5D
NSJ@-TQ@@(B)-M3D
Unit version 3.0
Function Support by Unit Version
The following tables show the functions supported by the CX-Programmer and
CX-Simulator depending on the unit version of the CPU Unit. Refer to 1-1-4
Summary of CX-Simulator Functions (Comparisons with Actual PLC) and 1-6
Comparison of CX-Simulator and SYSMAC CS/CJ-series PLCs for compari-
sons between CX-Simulator functions and the actual PLC.
The functions supported for CJ2 CPU Units with unit version 1.0 correspond to
those for CS/CJ Units with unit version 4.0 or later.
• Functions Supported for Unit Version 4.0 or Later
The following tables list the functions added for unit version 4.0 and supported
by the CX-Programmer. CX-Programmer version 7.0 or higher and
CX-Simulator version 1.7 or higher are required to use these functions.
Additional functions are supported if CX-Programmer version 7.2 or higher is
used.
CS1-H CPU Units
CS1@-CPU@@H
Function
Unit version 4.0 or
later
Other unit versions
Online editing of function blocks
Note: This function cannot be used for simulations on the
CX-Simulator.
OK ---
Input-output variables in function blocks OK ---
Text strings in function blocks OK ---
Number-Text String Conversion Instructions:
NUM4, NUM8, NUM16, STR4, STR8, and STR16
OK --- New application
instructions
TEXT FILE WRITE (TWRIT) OK ---
Using ST language programming in tasks OK with CX-
Programmer Ver. 7.2 or
higher
---
Using SFC programming in tasks OK with CX-
Programmer Ver. 7.2 or
higher
---
CS1D CPU Units
Unit version 4.0 is not supported.
To Next Page
Loading...
