Applicable PLC models and Computers Section 1-4
14
1-4 Applicable PLC models and Computers
1-4-1 Applicable PLC models
The CX-Simulator supports the following PLC (Programmable Controller)
models.
Series CPU Unit Model
CS CS1H-CPU67/66/65/64/63
CS1G-CPU45/44/43/42
CS1H-CPU67H/66H/65H/64H/63H
CS1G-CPU45H/44H/43H/42H
CS1D-CPU67H/65H
CS1D-CPU67S/65S/44S/42S
CJ CJ2H-CPU68/67/66/65/64 (See note 3.)
CJ2H-CPU68-EIP/67-EIP/66-EIP/65-EIP/64-EIP
(See note 3.)
CJ1H-CPU67H-R/66H-R/65H-R/64H-R
CJ1M-CPU23/22/13/12/11
CJ1H-CPU66H/65H/67H
CJ1G-CPU45H/44H/43H/42H
CJ1G-CPU45/44
CP (See note 1.) CP1H-XA@@@@-@
CP1H-X@@@@-@
CP1H-Y@@@@-@
CP1L-M@@@@-@
CP1L-L@@@@-@
NSJ
(Controller Section)
(See note 2.)
G5D (Used for the NSJ5-TQ0@-G5D,
NSJ5-SQ0@-G5D, NSJ8-TV0@-G5D,
NSJ10-TV0@-G5D, and NSJ12-TS0@-G5D)
M3D (Used for the NSJ5-TQ0@-M3D,
NSJ5-SQ0@-M3D, and NSJ8-TV0@-M3D)
Note
1. In this manual, always assume that " CS/CJ-series PLC" also implies
CP-series PLCs unless otherwise specified. When performing simula-
tions for a CP-series PLC, use the instructions for the CS/CJ-series PLC.
Unit version 1.0 or 1.1 of the CP-series CPU Units is equivalent to unit
version 3.0 of the CS/CJ-series CPU Units. Functions added for unit
version 4.0 or later of the CS/CJ-series CPU Units are not supported by
the CP-series CPU Units. Functions not supported by CP-series PLCs,
however, cannot be simulated.
2. In this manual, always assume that "CJ-series PLC" also implies the
Controller Section of an NSJ-series NSJ Controller unless otherwise
specified. When performing simulations for the Controller Section of the
NSJ Controller, use the instructions for the CJ-series PLC.
3. The functions supported for CJ2-series CPU Units correspond to those
for CS/CJ-series Units with unit version 4.0 or later.
To Next Page
Loading...
