Omron ZEN User Manual

xv
Precautions
Precautions
WARNING
Serious human hazard may occasionally occur due to ignition or rupture of
the lithium battery used in the Battery Unit. Do not short the battery
terminals or charge, disassemble, deform under pressure, or incinerate
the battery.
Never use any battery that has been dropped on the floor or otherwise
subjected to excessive shock.
CAUTION
Electric shock, fire, or malfunction may occur. Do not disassemble, modify,
or repair the ZEN or touch any of the internal parts.
Electrical shock may occur. Never touch the I/O terminals, computer
connector, Expansion Unit connector, or Battery Unit connector while
power is being supplied.
Electrical shock may occur. Do not remove the Expansion Unit connector
cover unless an Expansion I/O Unit will be permanently installed.
Fires may occasionally occur. Tighten the terminal screws to a torque of
0.565 to 0.6 N·m (5 to 5.3 in-lb).
Z211-E1-03.book Page xv Friday, November 21, 2008 10:38 AM

Omron ZEN Specifications

General

Display	LCD
Mounting Type	DIN Rail
Operating Temperature	-10 to 55°C
Power Supply Voltage	100-240V AC
Output Type	Relay, Transistor
Number of Outputs	4-8
Programming Language	Ladder Logic