Oracle Netra SPARC T4-1B User Manual

114 Netra SPARC T4-1B Server Module Service Manual • June 2012
1. Prepare to take all ESD precautions when working with both the original server
module and the new enclosure assembly.
Prepare to place all components on an antistatic mat unless you install each
component immediately in the new enclosure assembly.
Follow the precautions explained in “Preparing for Service” on page 51.
2. Remove the top cover from the original server module and the new enclosure
assembly.
See “Remove the Cover” on page 63.
3. Transfer the drives from the original server module to the enclosure assembly.
See “Servicing Drives” on page 65.
4. Transfer the drive fillers from the original server module to the enclosure
assembly.
See “Remove a Drive Filler” on page 70 and “Install a Drive Filler” on page 73.
5. Transfer the FEM (if present) from the original server module to the enclosure
assembly.
Install the FEM in the same connectors in the enclosure assembly. See “Servicing
the FEM” on page 93.
6. Remove the REM (if present) from the original server module.
See “Servicing the REM” on page 89.
Before installing the REM in the enclosure assembly, move the SP card to the
enclosure assembly. See Step 7.
7. Transfer the SP card from the original server module to the enclosure assembly.
See “Servicing the SP Card” on page 97.
8. Install the REM (if present) into the enclosure assembly.
See “Servicing the REM” on page 89.
9. Transfer the ID PROM from the original server module to the enclosure
assembly.
See “Servicing the ID PROM” on page 101.
10. Transfer the USB flash drive (if present) from the original server module to the
enclosure assembly.
Ensure that you install a USB flash drive only in the top slot of the connector. See
“Servicing a USB Flash Drive” on page 105.

Oracle Netra SPARC T4-1B Specifications

General

Brand	Oracle
Model	Netra SPARC T4-1B
Category	Server
Language	English