Oracle ZFS User Manual

Installing a Sun Disk Shelf
Caution - This procedure requires a minimum of two people, or a mechanical lift, because of
the weight of the chassis. Attempting this procedure alone could result in equipment damage or
personal injury. Always load the heaviest equipment (disk shelves) at the bottom of the rack.
Before You Begin
Extend all anti-tilt and stabilization devices from the bottom of the rack.
1.
If you are using a universal 19-inch or Sun Rack II cabinet, snap an M6 square
cage nut into the 4U location where you will be installing the system. Install in
the top and bottom holes.
2.
Install appropriate rail plates in four locations on the rack (2 front and 2 back) by
aligning the two pins on the rail plate with holes on the cabinet rails.
110 Oracle ZFS Storage Appliance Installation Guide, Release OS8.8.x • August 2021

Oracle ZFS Specifications

General

Category	Storage
Operating System	Oracle Solaris
Protocol Support	NFS, SMB, iSCSI, FC
Data Protection	Snapshots, Clones, Replication
Encryption	AES-256 encryption for data at rest
Integration	Oracle Database
RAID Levels	RAID-Z2, RAID-Z3
Data Deduplication	Yes
Data Integrity	Checksums
High Availability	Redundant hardware
Maximum Capacity	Petabytes
Management	Command-line interface (CLI)