Oracle ZFS - Page 141

To Next Page

To Previous Page

Installing a ZS7-2 Cable Management Arm

Gently tug on the right side of the front slide bar to verify that connector B is

properly seated.

Callout Description

1 Connector B tab

2 Right slide-rail front slot

To install CMA connector C into the right slide-rail:

Installing a ZS7-2 Controller 141

Main Page

Table of Contents7
Installation Overview13
Installation Prerequisites and Hardware Overviews15
Prerequisites for Installation15
Security Information16
Safety Information16
Cabinet and Tool Requirements16
Disconnecting an RJ-45 Cable18
Cabinet Configuration Guidelines19
Cabinet Configuration19
Load Distribution19
Cable Lengths20
Cable Bend Radius20
Supported Disk Shelf Combinations and Hbas21
Maximum Disk Shelves Per Controller Configuration22
Overview of Disk Shelves25
Oracle Storage Drive Enclosure DE3-2425
Oracle Storage Drive Enclosure DE2-2433
Sun Disk Shelf39
Disk Shelf Components43
Overview of ZS9-2 Controller44
ZS9-2 Physical Specifications44
ZS9-2 Electrical Specifications45
ZS9-2 Acoustic Noise Emissions45
ZS9-2 Configuration Options45
ZS9-2 Front Panel Components46
ZS9-2 Rear Panel Components48
Overview of ZS7-2 Controller49
ZS7-2 Physical Specifications49
ZS7-2 Electrical Specifications49
ZS7-2 Acoustic Noise Emissions50
ZS7-2 Configuration Options50
ZS7-2 Front Panel Components51
ZS7-2 Rear Panel Components52
Overview of ZS5-4 Controller53
ZS5-4 Physical Specifications53
ZS5-4 Electrical Specifications54
ZS5-4 Acoustic Noise Emissions54
ZS5-4 Configuration Options54
ZS5-4 Front Panel Components55
ZS5-4 Rear Panel Components56
Overview of ZS5-2 Controller57
ZS5-2 Physical Specifications57
ZS5-2 Electrical Specifications57
ZS5-2 Acoustic Noise Emissions58
ZS5-2 Configuration Options58
ZS5-2 Front Panel Components58
ZS5-2 Rear Panel Components59
Cable Management Arm60
Overview of ZS4-4 Controller62
ZS4-4 Front Panel Components62
ZS4-4 Rear Panel Components63
Overview of ZS3-4 Controller66
ZS3-4 Electrical Specifications66
ZS3-4 Configuration Options66
ZS3-4 Front Panel Components67
ZS3-4 Rear Panel Components68
Overview of ZS3-2 Controller70
ZS3-2 Physical Specifications70
ZS3-2 Electrical Specifications70
ZS3-2 Acoustic Noise Emissions71
ZS3-2 Configuration Options71
ZS3-2 Front Panel Components71
ZS3-2 Rear Panel Components72
Optional Cable Management Arm75
Overview of 7420 Controller76
7420 Physical Specifications76
7420 Electrical Specifications76
7420 Configuration Options77
7420 Front Panel Components78
7420 Rear Panel Components79
Overview of 7320 Controller80
7320 Electrical Specifications81
7320 Base Configurations81
7320 Front Panel Components82
7320 Rear Panel Components83
Overview of 7120 Controller84
7120 Physical Specifications84
7120 Electrical Specifications84
7120 Front Panel Components85
7120 Rear Panel Components86
Installing Disk Shelves89
Installing a DE3-24P Disk Shelf89
Installing a DE3-24C Disk Shelf93
Installing a DE2-24P Disk Shelf99
Installing a DE2-24C Disk Shelf104
Installing a Sun Disk Shelf109
Installing a ZS9-2 Controller115
Installing the Slide Rails Onto a ZS9-2115
Installing the Slide Rails into the Rack for a ZS9-2116
Installing a ZS9-2 Onto the Rack Slide Rails118
Installing a ZS9-2 Cable Management Arm120
Verifying Operation of ZS9-2 Slide-Rails and CMA128
Installing a ZS7-2 Controller131
Installing the Slide Rails Onto a ZS7-2131
Installing the Slide Rails into the Rack for a ZS7-2132
Installing a ZS7-2 Onto the Rack Slide Rails134
Installing a ZS7-2 Cable Management Arm136
Verifying Operation of ZS7-2 Slide-Rails and CMA144
Installing a ZS5-4 Controller147
Installing the Slide Rails Onto a ZS5-4147
Installing the Slide Rails into the Rack for a ZS5-4148
Installing a ZS5-4 Onto the Rack Slide Rails150
Installing a ZS5-4 Cable Management Arm152
Verifying Operation of ZS5-4 Slide-Rails and CMA154
Installing a ZS5-2 Controller157
Installing the Mounting Brackets and Slide Rail Assemblies for a ZS5-2157
Installing a ZS5-2 Onto the Rack Slide Rails163
Installing a ZS5-2 Cable Management Arm164
Verifying Operation of ZS5-2 Slide-Rails and CMA174
Installing a ZS4-4 or ZS3-4 Controller175
Installing the Slide Rails Onto a ZS4-4 or ZS3-4175
Installing the Slide Rails into the Rack for a ZS4-4 or ZS3-4176
Installing a ZS4-4 or ZS3-4 Onto the Rack Slide Rails178
Installing a ZS4-4 or ZS3-4 Cable Management Arm181
Installing a ZS3-2 Controller185
Installing the Mounting Brackets and Slide Rail Assemblies for a ZS3-2185
Installing a ZS3-2 Onto the Rack Slide Rails191
Installing a ZS3-2 Cable Management Arm192
Verifying Operation of ZS3-2 Slide-Rails and CMA201
Installing a 7X20 Controller203
Removing the 7X20 Mounting Brackets from Inside the Slide Rails203
Installing the Mounting Brackets on a 7X20205
Installing a 7X20 Onto the Rack Slide Rails207
Installing a 7X20 Cable Management Arm212
Cabling the Appliance219
Connecting System Cables219
Connecting Cluster Cables220
Connecting Cluster Cables for ZS9-2 Controllers220
Connecting Cluster Cables for ZS7-2, ZS5-X, ZS4-4, ZS3-X, and 7X20 Controllers221
Controller Cluster I/O Ports225
Connecting Disk Shelf Cables228
Powering on the Appliance231
Powering on a DE3-24 or DE2-24 Disk Shelf231
Powering on a Sun Disk Shelf233
Powering on a Controller233
Powering off a Controller234
Powering off a Disk Shelf235
Configuring the Appliance for the First Time237
Configuring the System238
Performing Initial Configuration (BUI)241
Performing Initial Configuration (CLI)256
Troubleshooting Hardware Faults265
Connecting to Oracle ILOM265

Oracle ZFS - Page 141

Table of Contents

Related product manuals