Panasonic 2WAY Multi - Page 159

V–40
11) Hot water setting (Level 2)
Rejection conditions : Not accepted during indoor operation
Setting start operation method : Press the SET (S007) key for one second.
Setting change operation method : After entering the setting start operation mode, operating the UP
(S005) and DOWN (S006) keys makes it possible to change the setting
values. (TEST/WARNING LED light)
Example:

: When pressing the UP (S005) key

: When pressing the DOWN (S006) key
Setting confi rm operation method : After entering the setting start operation or setting change operation
completed, press the SET (S007) key for one second. (TEST/
WARNING LED off)
Setting cancel operation method : Press the HOME (S004) key for one second before confi rming setting.
Setting range : 00 to 99
0 No discharge

1 Hot water discharge thermostat off temperature

~to ~
99 •

12) Oil change display setting (Level 2)
Rejection conditions : Not accepted during indoor operation
Setting start operation method : Press the SET (S007) key for one second.
Setting change operation method : After entering the setting start operation mode, operating the UP
(S005) and DOWN (S006) keys makes it possible to change the setting
values. (TEST/WARNING LED light)
Example:

: When pressing the UP (S005) key

: When pressing the DOWN (S006) key
Setting confi rm operation method : After entering the setting start operation or setting change operation
completed, press the SET (S007) key for one second. (TEST/
WARNING LED off)
Setting cancel operation method : Press the HOME (S004) key for one second before confi rming setting.
Setting range : 00 to 03
0 Inspection and error

1None

2Error only

3Inspection only

13) Single phase setting (Level 2)
Rejection conditions : Not accepted during indoor operation
Setting start operation method : Press the SET (S007) key for one second.
Setting change operation method : After entering the setting start operation mode, operating the UP
(S005) and DOWN (S006) keys makes it possible to change the setting
values. (TEST/WARNING LED light)
Example:

: When pressing the UP (S005) key

: When pressing the DOWN (S006) key
Setting confi rm operation method : After entering the setting start operation or setting change operation
completed, press the SET (S007) key for one second. (TEST/
WARNING LED off)
Setting cancel operation method : Press the HOME (S004) key for one second before confi rming setting.
Setting range : 00 to 01
0•

1 Single phase

GHPtroubleshooting.indbV‒40GHPtroubleshooting.indbV‒40 2012/11/2611:20:222012/11/2611:20:22