4.2 Settings in Configurator PMX
4-17
4.2.5 Check on Parameter Data
• The following procedure is explained on the condition that the Configurator PMX has already
started.
1. Select “Debug” > “Check Parameter and Data Values” from the menu bar.
A message box appears to show the check result. If there is an error in the
settings for the positioning data tables, an error message will appear and the
cursor will move to the corresponding error position.
4.2.6 Writing Parameters to Unit (1)
• Information on parameters that have been set is transferred to the unit along with information
on programs, comments and system registers.
• The following procedure is explained on the condition that the Configurator PMX has already
started.
1. Select “File” > “Save changes and exit” from the menu bar of the
Configurator PMX.
2. When "Do you save the setting?" appears, press [Yes (Y)].
3. Select “Online” > “Download To PLC (Entire project)” from the FPWIN GR7
menu bar.
Positioning data will also be downloaded to the control unit along with information
on programs, comments and system registers.
To Next Page
Loading...
