Settings of Control Unit
4-18
4.2.7 Writing Parameters to Unit (2)
• Information on parameters that have been set can also be downloaded to the unit in the
Configurator PMX.
• The following procedure is explained on the condition that the Configurator PMX has already
started.
1. Select "File" > "Download positioning data" from the menu bar of the
Configurator PMX.
A message box for confirming the saving appears.
2. Press the [Yes] button.
A message confirming the download to the PLC appears. In the RUN mode, a
message confirming that the mode is switched to the PROG. mode also appears.
3. Press the [Yes] button.
A message confirming the switching of the operation mode appears.
4. Press the [Yes] button to switch the operation mode.
To Next Page
Loading...
