Panasonic FP0H

11.2 Differences in Positioning Instructions with FP
11-5
11.2 Differences in Positioning Instructions with FPΣ
11.2.1 High-speed Counter/Pulse Output Control Instruction F0(MV)
For the FPΣ mode, the following contents are common to FPΣ.
- Control code monitor area
- Allocation of control codes
 Control code monitor area
Channel
no.
Conventional model
FP
Σ
series
FP0H series
FP
Σ
mode
FP0H mode
CH0 DT90190 DT90190 DT90380
CH1 DT90191 DT90191 DT90381
CH2 DT90192 DT90192 DT90382
CH3 DT90193 DT90193 DT90383
 Allocation of control codes
Conventional model FPΣ and FP0H series (FPΣ mode)
High-speed counter/Pulse output control
bit no.
15 43210
Near home input
Reset input setting
0: Valid, 1: Invalid
High-speed counter instruction clear
pulse output stop
0: Continue, 1: Clear, stop
Channel specification
H0 to H3: CH0 to CH3
Software reset
0: Disable, 1: Enable
Count
0: Enable 1: Disable
0: Invalid, 1:Valid
FP0H series (FP0H mode)
High-speed counter control
Pulse output control
bit no.
15
3 2 1 0
Software reset
0
0: Disable 1: Enable
Count
0: Enable 1: Disable
Reset input setting
0: Valid
1
: Invalid
High
-speed counter
instruction clear
0: Continue 1: Clear
Channel specification
H0 to H3: CH0 to CH3
H0: Fixed
8
bit no.
15 4 3 1 0
Software reset
1
0: Disable 1: Enable
Count
0: Enable 1: Disable
Pulse output stop
0: Continue 1: Stop
H1: Fixed
8
Near home input
0: Invalid 1: Valid
Channel specification
H0
to H3: CH0
to CH3