Instruction References
7-18
7.2.3 [F172(PSLH)] Pulse Output (JOG Operation)
Outputs the pulse of a specified parameter from a specified channel.
Instruction format
Operand
S
Starting number of the area in which data tables are registered
n
Target channel for pulse output
Memory area type that can be specified
Operand WX WY WR WL SV EV DT LD I
Index
modifier
Outline of operation
• Outputs pulses from a specified channel when a corresponding control active flag is OFF
and the execution condition is ON. The output is performed when the trigger (execution
condition) is on.
• By specifying the addition counting or subtraction counting mode for the control code, it can
be used for the instruction for activating JOG operation.
• The frequency can be changed in each scan, or the target value can be changed
asynchronously. However, the control code cannot be changed during the execution of an
instruction.
For setting the frequency to 50 kHz or more, specify the duty of 1/4 (25%).
To Next Page
Loading...
