Panasonic KX-TGP600 - Page 53

"VM_NUMBER_2": for line 2, …,
"VM_NUMBER_8": for line 8
Note
• The number of lines available varies depending on the phone being used, as follows:
– KX-TGP600: 1–8
• Some parameter values can be specified as "empty" to set the parameter values to empty.
Example:
NTP_ADDR=""
• The parameters have no order.
• If the same parameter is specified in a configuration file more than once, the value specified first is applied.
• All configurable settings can be specified in the configuration file. You can ignore settings that already have
the desired values. Only change parameters as necessary.
• Boolean parameters (BOOLEAN) accept all of the following configurations.
"Y": "Y", "y", "Yes", "YES", "yes"
"N": "N", "n", "No", "NO", "no"
Parameter Extensions
You can use parameter extensions to specify parameters as Read-Only or Carrier Default.
Read-Only Specification
• When "?R" or "?r" is specified, the phone user interface and Web user interface for the parameter in
question is restricted to Read-Only.
* Restricting the phone user interface to Read-Only
The Read-Only parameter settings menu appears, but an error occurs during registration.
* Restricting the Web user interface to Read-Only
The Read-Only parameter settings menu appears grayed out and nothing can be entered.
Note
• Parameters that can be configured from the device and from the Web can be confirmed from
footnotes 1-3 on the parameter names in "5.1 Configuration File Parameter List".
• When "?R" or "?r" is not specified, the phone user interface and Web user interface are both readable and
writable.
* Optional specifications for "?R" and "?r" are enabled when the last parameter in question is configured.
Carrier Default Specification
• When "?!" is specified, applicable parameter values are managed as carrier default values when applied
to operational information.
* Carrier default values are applied once a reset to carrier defaults is executed. Carrier defaults will also
be initialized when a reset to device defaults is executed.
* Once "?!" is specified, the parameter in question will be designated as a carrier default even if said
parameter is configured without "?!". (This setting will remain in place until restored to factory default.)
Specification of Multiple Parameter Extensions
• One parameter can be assigned multiple extensions.
Example: XXX?R?!="" / XXX?!?r=""
Parameter Extension Configuration Example
1. In the configuration file, set IP Addressing Mode to IPv4 and Read-Only
Example parameter: IP_ADDR_MODE?R="0" ("0": IPv4)
2. If an error occurs when attempting to set the IP Mode to IPv6 using the KX-TPA60, see To configure IP
Mode (IPv4, IPv6, IPv4&IPv6) in Configuring the Network Settings of the Unit.
Document Version 2017-07 Administrator Guide 53
2.4 Configuration File Specifications