3-114 Features
S 3 Features
(5) Dial number
Outgoing call: shows the called party’s telephone number
(maximum 32 digits). Valid digits are 0 through 9, or #.
Received call: shows <incoming>. If a Caller ID is assigned
to the other party, it will show <incoming> and the number.
An incoming call via DISA is shown as <DISA incoming>.
An incoming call via DIL is shown as <DIL incoming>.
(6) Duration: shows the duration of the call in
hours/minutes/seconds.
(7) Code: shows the account code appended to the call, account
code index number, the extension number which
overrides toll restriction or the DISA security code
status. Code “0” indicates a DISA incoming call
without a DISA security code. Codes “1 to 4”
indicate a DISA incoming call with DISA security
code 01 to 04 respectively. DISA security codes are
never printed out by SMDR.
Conditions • This system can store information of up to 64 calls.
• This data is not deleted when the user resets the system.
• If FLASH is manually sent during a conversation to make another call
without hanging up, etc., the call record will be printed out and a new
record is started. “F/” will be printed at the top of the dial number on the
new record.
• When a host PBX code is entered, “=” will be printed between the code
and dialed number.
Connection Reference
Section 2, Installation
2.3.9 Printer and PC Connection
Programming References
Section 4, System Programming
[000] Date and Time Setting
[204] Call Duration Count Start Time
[800] SMDR RS-232C Communication Parameters
[801] SMDR Parameter
[802] Incoming/Outgoing Call Selection for Printing
[803] Secret Speed Dialing/One-Touch Dialing Printing
[804] System Data Dump
[805] SMDR Account Code Selection
[906] Caller ID SMDR Format
[907] Caller ID SMDR Printout Selection
Feature References None
Operation References Not applicable.
To Next Page
Loading...
