4.2 System Programming
Hold Mode Selection
4-24 System Programming
Operation
104
Hold Mode To hold To transfer
Hold-1
Hold-2
Hold-3
Description Assigns the call hold mode for single line telephones.
Each mode is explained as follows.
Selection Hold-1 / Hold-2 / Hold-3
Default Hold-1
Programming 1. Enter 104.
Display: Hold Mode
2. Press NEXT.
Display example: Hold-1
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press STORE.
5. Press END.
Conditions None
Feature References Section 3, Features
Call Hold – Intercom
Call Hold – Outside (CO) Line
Flash the hookswitch + on-hook
Flash the hookswitch
+ feature number (20) + on-hook
Flash the hookswitch
+ feature number (20) + on-hook
Flash the hookswitch
+ extension number or line access code
Flash the hookswitch
+ extension number or line access code
Flash the hookswitch
+ feature number (20)
+ extension number or line access code
To Next Page
Loading...
