4.2 System Programming
Flash Key Mode
4-30 System Programming
110
Description Assigns sending a flash signal when the FLASH/RECALL button
on a proprietary telephone is pressed.
Selection MODE 1 (A flash signal is sent during the time programmed in
program “[418] Flash Time”)
MODE 2 (A flash signal is sent while the FLASH/RECALL
button is pressed.)
Default MODE 2
Programming 1. Enter 110.
Display: Flash Key
2. Press NEXT.
Display example:MODE 1
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press STORE.
5. Press END.
Condition • For MODE 2, a flash signal will be sent for the programmed time in
program [418] if the FLASH/RECALL button is pressed for less than
the programmed time.
Feature References Section 3, Features
External Feature Access
Flash
To Next Page
Loading...
