4-116 System Programming
4.2 System Programming
Doorphone Chime Assignment
Description Assigns each doorphone to the relay to which a doorbell/door
chime should be connected, when assigned “Chime” or “Ring &
Chime” in program [710]. One doorbell/door chime is available for
any doorphone. The relay other than the relays connected to door
openers should be selected.
Selection • Doorphone number: 1 – 2, ( = all doorphones)
• Relay 1 / Relay 2
Default All doorphones — Relay 2
Programming 1. Enter 711.
Display: Chime Assign
2. Press NEXT.
Display: Door NO? →
3. Enter a doorphone number.
Pressing NEXT also can enter doorphone number 1.
Display example: DP-1:Relay 2
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another doorphone, press NEXT or PREV, or
SELECT and enter the desired doorphone number.
7. Repeat steps 4 through 6.
8. Press END.
Condition • To assign all doorphones to the same selection, press the key in
step 3. In this case, the display will show: DP- :Mixed.
Feature References Section 3, Features
Doorbell/Door Chime
Doorphone Call
711
To Next Page
Loading...
