4.2 System Programming
DTMF Receiver Check
System Programming 4-27
107
Description Enables or disables the DTMF receiver to check whether the
DTMF receivers are activated normally or not.
Two DTMF receivers work with the following card.
DTMF-R 1 and 2 — basic extension card (jacks 01 – 08)
Selection • DTMF Receiver number: 1 – 2, ( = all DTMF receiver)
• Enable / Disable
Default All DTMF receivers — Enable
Programming 1. Enter 107.
Display: DTMF-R Selection
2. Press NEXT.
Display:DTMF-R NO? →
3. Enter the DTMF receiver number.
Pressing NEXT also can enter DTMF receiver number 1.
Display example:DTMF-R1:Enable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another DTMF receiver, press NEXT or PREV,
or SELECT and enter the desired DTMF receiver number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions None
Feature References None
To Next Page
Loading...
