4-124 System Programming
4.2 System Programming
System Data Dump
804
Description Starts or stops printing the assigned data. All or a specific area of
current programmed data is printed out. The areas are as follows.
All Para: All data
System Para: All data except the following programs.
CO Para: Programmed data of [400]–[403], [405]–[423],
[435]–[437], [900] and [913].
Ext Para: Programmed data of [516], [600]–[618], [904], [909]
and [963] if a proprietary telephone is connected.
The assigned data on the CO buttons are also printed
out.
Programmed data of [516], [600]–[612] and [963] if
a single line telephone is connected. The stored
Personal Speed Dialing numbers are also printed
out.
Speed Dial: Programmed data of [001], [011]
Stop Output: Stops printing.
Selection All Para / System Para / CO Para + outside (CO) line number:
1 – 3, ( = all outside (CO) lines) /
Ext Para + jack number: 01 – 08, ( = all jacks) /
Speed Dial / Stop Output
Default Not applicable.
Programming 1. Enter 804.
Display: System Data Dump
2. Press NEXT.
Display: Menu:All Para
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press STORE.
5. If CO Para or Ext Para is selected, enter an outside (CO) line
number or a jack number.
6. Press STORE.
7. Press END.
To Next Page
Loading...
