System Programming 4-115
4.2 System Programming
Doorphone Ring/Chime Selection
Description Assigns an incoming doorphone call ringing way for each
doorphone. The ringing way depends on the selection as follows,
when a visitor presses the doorphone button:
Ring: Rings an extension pre-assigned in programs [700]-[702].
Chime: Chimes instead of ringing.
Ring & Chime: Rings a pre-assigned extension and chimes
simultaneously.
Selection • Doorphone number: 1 – 2, ( = all doorphones)
• Ring / Chime / Ring & Chime
Default All doorphones — Ring
Programming
1. Enter 710.
Display: Door Ring/Chime
2. Press NEXT.
Display: Door NO? →
3. Enter a doorphone number.
Pressing NEXT also can enter doorphone number 1.
Display example: DP-1:Ring
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another doorphone, press NEXT or PREV, or
SELECT and enter the desired doorphone number.
7. Repeat steps 4 through 6.
8. Press END.
Condition • To assign all doorphones to the same selection, press the key in
step 3. In this case, the display will show: DP- :Mixed.
Feature References Section 3, Features
Doorbell/Door Chime
Doorphone Call
710
To Next Page
Loading...
