4.2 System Programming
Call Transfer to an Outside (CO) Line
4-100 System Programming
Description Enables or disables performing the Call Transfer to an Outside
(CO) Line feature.
Selection • Jack number: 01 – 08, ( = all jacks)
• Enable / Disable
Default All jacks – Disable
Programming 1. Enter 606.
Display: Transfer to CO
2. Press NEXT.
Display: Jack NO? →
3. Enter a jack number.
Pressing NEXT also can enter jack number 01.
Display example: #01:Disable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another jack, press NEXT or PREV, or
SELECT and enter the desired jack number.
7. Repeat steps 4 through 6.
8. Press END.
Condition • To assign all jacks to the same selection, press the key in step 3. In
this case, the display will show: # :Mixed.
Feature Reference Section 3, Features
Call Transfer, Screened – to an Outside (CO) Line
606
To Next Page
Loading...
