4.2 System Programming
Caller ID Call Waiting CAS Receive Time
System Programming 4-137
Description The telephone company calls the system “Customer Premise
Equipment (CPE)”. If you have a Caller ID Call Waiting during a
conversation, the telephone company will send to the CPE a CAS
(CPE Alerting Signal). If the CAS duration is too long or too short,
the CAS is ignored. If the CAS is accepted, then the system will
respond and the Caller ID Call Waiting feature will be performed.
This program assigns the allowable CAS duration. Normally, it
should not be necessary to change the default setting.
Selection •
Mode 1 (40 ms through 120 ms) / Mode 2 (64 ms through 96 ms) /
Mode 3 (72 ms through 96 ms)
Default Mode 3
Programming 1. Enter 914.
Display: C.W CID Receive
2. Press NEXT.
Display example: MODE 3
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press STORE.
5. Press END.
Condition • This program is available when “Enable” is assigned in programs [900]
“Caller ID Assignment” and [913] “Caller ID Call Waiting
Assignment”.
Feature Reference Section 3, Features
Caller ID Call Waiting
914
To Next Page
Loading...
