4.2 System Programming
Hunting Group Set
4-22 System Programming
100
Description Assigns to enable or disable the station hunting feature for each
extension group.
Selection • Extension group number: 1 – 8, ( = all extension groups)
• Disable / Enable
Default All extension groups — Disable
Programming 1. Enter 100.
Display: Hunting Group
2. Press NEXT.
Display: Group NO? →
3. Enter an extension group number.
Pressing NEXT also can enter extension group number 1.
Display example: Group1:Disable
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another extension group, press NEXT or PREV,
or SELECT and enter the desired extension group number.
7. Repeat steps 4 through 6.
8. Press END.
Conditions • Program [600] “Extension Group Assignment” is used to assign the
extension group members.
• To assign all extension groups, press the key in step 3. In this case,
the display will show: Group :Mixed.
Feature Reference Section 3, Features
Station Hunting
To Next Page
Loading...
