4.1.1 Using Proprietary Telephones
System Programming 4-3
Using the Overlay
A programming overlay is packed with the telephone at the factory.
This overlay should be used at all times during programming. The
features of the telephone keys change during programming as
follows. (The original features are in parentheses.)
During Normal Operation During Programming
(PAUSE) PAUSE
(SP-PHONE)/ NEXT
(REDIAL)/ PREV (PREVIOUS)
(AUTO ANSWER/MUTE) SELECT
(FLASH/RECALL) FLASH
(TRANSFER) CLEAR
(FWD/DND)/
(CONF)/ , –
(INTERCOM ) SECRET
(AUTO DIAL/STORE) STORE
(HOLD) END
(PROGRAM) PROGRAM
Location of Controls with the Overlay
The picture below shows the feature of the buttons of the
KX-TA30830 during programming.
To Next Page
Loading...
