4-72 System Programming
4.2 System Programming
Calling Party Control (CPC) Signal (contd.)
420
6. To program another outside (CO) line, press NEXT or
PREV, or SELECT and enter the desired outside (CO) line
number.
7. Repeat steps 4 and 6.
8. Press END.
Conditions • To assign all outside (CO) lines to the same selection, press the key
in step 3. In this case, the display will show: CO : N= Mixed.
• Program [421] “CPC Detection for Outgoing Calls” is used to program
CPC Signal Detection for outgoing outside calls.
Feature Reference Section 3, Features
Calling Party Control (CPC) Signal Detection
To Next Page
Loading...
