4.2 System Programming
Extension Access to Local Carrier-Based Voice Mail Assignment
System Programming 4-79
Description Selects which extensions can access the voice mail service offered
by the telephone company on an outside (CO) line basis. When set
up as described below, the system flashes the corresponding CO
button (red, moderately) and lights the Message/Ringer Lamp when
a message is stored in the mailbox at the telephone company.
Selection • Outside (CO) line number: 1 – 3, ( = all outside (CO) lines)
• Jack number: 01 – 08, ( =all jacks)
• Enable / Disable
Default All outside (CO) lines — all jacks — Enable
Programming 1. Enter 437.
Display: CO VM Service
2. Press NEXT.
Display: CO NO? →
3. Enter an outside (CO) line number.
Pressing NEXT also can enter outside (CO) line number 1.
Display example: CO 1:#01:Enable
4. Enter a jack number after pressing the # key.
The user can also keep pressing or until the desired
outside (CO) line number is displayed.
5.
Keep pressing SELECT until the desired selection is displayed.
6. Press STORE.
7. To program another jack, press
or , or # and enter the
desired jack number.
8. Repeat steps 5 through 7.
9. To program another outside (CO) line, press NEXT or PREV,
or SELECT and the desired outside (CO) line number.
10. Repeat steps 4 through 9.
11. Press END.
Condition • To assign all outside (CO) lines or all jacks to the same selection, press
the key in step 3 or step4.
In these cases, the display will show: CO :
# :Mixed.
Feature Reference
Section 3, Features
Local Carrier-Based Voice Mail Service
437
To Next Page
Loading...
