4.2 System Programming
DISA No Dial Mode
System Programming 4-87
Description Selects the mode when nothing is dialed after a beep after a
programmed length of time for the DISA1 mode. There are two
modes as follows.
Intercept: the call is directed to the extensions assigned in
programs [408]–[410] for the time programmed in
[509] “DISA Ringing Time after Intercept”.
Disconnect: the call is disconnected.
Selection • Intercept / Disconnect
Default DISA1 — Intercept
Programming 1. Enter 510.
Display: DISA No Dial
2. Press NEXT.
Display example: DISA1:Disconnect
3. Keep pressing SELECT until the desired selection is
displayed.
4. Press STORE.
5. Press END.
Conditions None
Feature References Section 3, Features
Direct Inward System Access (DISA)
Intercept Routing
510
To Next Page
Loading...
