Address Program Default
5.2 Default Values
5-8 List
[800] SMDR RS-232C Communication
Parameters
[801] SMDR Parameter
[802] Incoming/Outgoing Call Selection for
Printing
[803] Secret Speed Dialing/One-Touch Dialing
Printing
[804] System Data Dump
[805] SMDR Account Code Selection
[900] Caller ID Assignment
[901] Caller ID Area Code Assignment
[902] Caller ID Modification for Local Calls
[903] Caller ID Modification for Long
Distance Calls
[904] Caller ID Log Priority Selection
[906] Caller ID SMDR Format
[907] Caller ID SMDR Printout Selection
[908] Caller ID Call Waiting Time
[909]
Common Area Call Log Check Assignment
[913
]
Caller ID Call Waiting Assignment
[914
]
Caller ID Call Waiting CAS Receive Time
[915] Caller ID Checksum
[963] Call Forwarding Selection
[968] Incoming Lamp Control
[998] ROM Version
[999] System Data Clear
New line code = CR+LF; Baud rate = 9600;
Word length = 8; Parity = Mark; Stop bit = 1
Page length — 66; Skip perforation — 0
Outgoing calls — On; Incoming calls — On
No printing
Not applicable.
CODE
All outside (CO) lines — Enable
All codes — Not stored
Deleted digits — 3; Added number — blank
Deleted digits — 0; Added number — 1
All jacks — Name
With CID
Disable
30 s
All jacks — Enable
All outside (CO) lines — Enable
Mode 3
Enable
All jacks — Disable
Disable
Not applicable.
Not applicable.
To Next Page
Loading...
