TRIO Panel Formwork
Instructions for Assembly and Use – Standard Configuration
Content
Overview
Main components 1
Key 2
Presentational reference 2
Introduction
Target groups 3
Additional technical documentation 3
Intended use 4
Instructions on use 4
Care and maintenance instructions 5
Safety instructions
Cross-system 6
System-specific 7
Storage and transportation 7
General
A1 Storage and transportation 8
– Stacking Device MAXIMO 8
– Setting down panels individually 10
– Turning panels individually 11
– Transportation on the construction site 12
– Putting loads into the stacking device 13
– Stacking Aid TRIO Corner 14
A2 Standard operating sequence 15
A3 Panels 19
– Panel overview 19
A4 Panel connections 21
– Alignment Coupler BFD 21
– Compensation Waler TAR 85 22
A5 Tie points 23
– Tie System DW 15 (Standard) 23
– Tie System DW 20 23
– Inclined anchorage with DW 15 24
A6 Push-Pull Props 25
– Brace Connector TRIO 25
– Base Plate RS 25
A7 Corners 27
– Right-angled corners 27
A8 Oblique Angles 29
– Obtuse and acute-angled corners 29
A9 T-junctions 30
– 90° T-junctions 30
– Obtuse-angle wall connections 31
A10 Offsets 32
– Wall offsets 32
– Height offsets 33
A11 Length compensations 34
– Timber supplied by contractor 34
– TRIO Filler Plate LA 34
– TRIO Filler Profile TPP 35
A12 Stopend formwork 36
– Stopend Panel TR 24 36
– Timber and filler plywood 36
– Stopend panel without water bar 37
– Stopend panel with water bar 38
– Stopend panel with expandable water bar 38
– Stopend Waler height 270 39
– Stopend Waler height 330 40
A13 Working and concreting platforms 41
– Concreting Platform TRIO 120 x 270 41
– Bracket System – MAXIMO MXK 51
– Scaffold Brackets TRG 80 and TRG 120 52
– Guardrail Post Holder TRIO 53
A14 Extensions 54
– Extensions up to h = 5.40 m 54
– Extensions up to h = 8.10 m 55
A15 Parapets, Foundations, Beams 56
– Tension and Compression Brace 56
– Foundation Tie Clamp TRIO TLS 57
– Foundation Strap TRIO 58
A16 Circular structures 59
– Polygonally formed TRIO Panels 59
A17 Shaft formwork 60
– Shaft Element TSE 60
System supplements
B1 TRIO 330 72
– Standard joint 72
– Combination 330 + 270 72
– External corners 72
– Obtuse and acute-angled corners 73
– Extension h = 330 + 270 73
– Extensions up to h = 5.40 m 74
– Extenions h = 6.00 m 74
– Extensions up to h = 8.10 m 75
B2 TRIO Alu 76
– TRIO Aluminium Panels 76
B3 TRIO Structure
77
– TRIO Structure Panels 77
Components
TRIO Panel Formwork 78
AuV TRIO EX.indb 1 11.10.17 09:44
To Next Page
