3
Introduction
Target groups
Additional technical documentation
* Valid in Germany: Regulations for
Occupational Health and Safety on
Construction Sites 30 (RAB 30).
** Instructions are given by the
contractor himself or a competent
person selected by him.
Poster: TRIO
Instructions for Use:
– Lifting Hook MAXIMO 1.5 t
– Lifting Gear Combi MX
– Lifting Gear MX
– Pallets and Stacking Devices
– Concrete Cones
– PERI Bio Clean
Data Sheet: Anchor Bolt PERI 14/20 x 130
PERI Design Tables – Formwork and Shoring
Brochure: TRIO
Contractors
These Instructions for Assembly and
Use are designed for contractors who
either
assemble, modify and dismantle the
formwork systems, or
use them, e.g. for concreting, or
allow them to be used for other work
operations, e.g. carpentry or electrical
work.
Competent person
(Construction Site Coordinator)
The Safety and Health Coordinator*
is appointed by the client,
must identify potential hazards during
the planning phase,
determines measures that provide
protection against risks,
creates a safety and health plan,
coordinates the protective measures
for the contractor and site personnel
so that they do not endanger each
other,
monitors compliance with the
protective measures.
Competent person qualified to carry
out inspections
Due to the specialist knowledge gained
from professional training, work experi-
ence and recent professional activity,
the competent person qualified to carry
out inspections has a reliable under-
standing of safety-related issues and
can correctly carry out inspections.
Depending on the complexity of the
inspection to be undertaken, e.g. scope
of testing, type of testing or the use of
a certain measuring device, a range of
specialist knowledge is necessary.
Qualified persons
Formwork systems may only be assem-
bled, modified or dismantled by person-
nel who are suitably qualified to do so.
For the work to be carried out, the quali-
fied persons must have received in-
structions** which contain at least the
following points:
Explanation of the plan for the assem-
bly, modification or dismantling of the
formwork in an understandable form
and language.
Description of the measures for
assembling, modifying or dismantling
the formwork.
Designation of the preventive meas-
ures to avoid the risk of persons and
objects falling.
Designation of the safety precautions
in the event of changing weather
conditions which could adversely
affect the safety of the formwork
system as well as the persons
concerned.
Details regarding the permissible
loads.
Description of any other risks that are
associated with the assembly, modifi-
cation or dismantling procedures.
In other countries, ensure that the
relevant national guidelines and
regulations in the respective cur-
rent version are complied with!
If no country-specific regulations
are available, it is recommended
to proceed according to German
rules and regulations.
A competent person must be
present on site during formwork
operations.
TRIO Panel Formwork
Instructions for Assembly and Use – Standard Configuration
AuV TRIO EX.indb 3 11.10.17 09:44
To Next Page
Loading...
