PG DRIVES TECHNOLOGY
127
CHAPTER 7 - WARNING SUMMARY
SK77898/2
Ensure that the charger plug pins are of the correct polarity
to be compatible with the pin polarity shown on the control
systems specific data sheet. Failure to observe this condition
could result in a burn hazard or fire hazard. PGDT accepts
no liability for losses of any kind arising from failure to
comply with this condition.
Do not disconnect batteries or open-circuit the circuit breaker
while charging is in progress. Failure to observe this
condition could result in a burns hazard or fire hazard.
PGDT accepts no liability for losses of any kind arising
from failure to comply with this condition.
Only use the battery charger that has been supplied with
your wheelchair. The use of incorrect chargers could damage
the batteries, wheelchair, control system or charger itself,
or may result in parts overheating creating the potential
for burns or even fire. PGDT accepts no liability for losses
of any kind if the charger is incompatible with the control
system (see Chapter 2, sections 7.1 and 7.2) or any other
part of the wheelchair system. Chapter 1 section 10.
2.5 Programming
Programming should only be conducted by healthcare
professionals with in-depth knowledge of PGDT electronic
control systems. Incorrect programming could result in an
unsafe set-up of a wheelchair for a user. PGDT accept no
liability for losses of any kind if the programming of the
control system is altered from factory pre-set values.
Chapter 1 section 11.
2.6 Joystick Knobs
Do not replace the joystick knob with any unauthorized
item it may cause hazardous operation. PGDT accepts no
liability for losses. Chapter 1 section 12.
2.7 Servicing
PGDT accept no liability for losses of any kind arising from
unauthorized opening, adjustment or modifications to the
VR2 control system.
To Next Page
Loading...